Hangar 9 VRTF Easy 2 Instruction Manual page 22

Stage 6 — Installing the Engine
Step 29. Center the throttle servo and adjust the clevis (screw
in/out) until the carburetor barrel is 1/2 open when the clevis is
attached to the outermost hole on the throttle servo arm.
Step 30. Install the muffler using the screws provided with the
engine.
Note: Some engines use Allen type hex bolts, and the hex
wrenches are included with the engine.
Insert the screws through the engine and mount the muffler. The
muffler screws must be very snug to prevent loosening under
vibration.
22
Step 31. Note the two colors of fuel tubing, clear and orange.
Attach the clear fuel line to the fuel nipple. Attach the orange fuel
line to the pressure nipple on the muffler.
Step 32. It's now time to fit the wing to the fuselage. Attach the
female connector of the aileron extension to the servo lead on
the switch harness. Center the wing on the fuselage, making
sure the aileron wire goes inside the fuselage. Take a rubber
band and put it over the front (leading edge) dowel and then
stretch it over the wing and attach it to the back (trailing edge)
dowel. Install all six rubber bands in this manner.
Note: Always go from the leading edge to the trailing edge
(front to rear).
CONTINUED