Balancing The Easy 2 - Hangar 9 VRTF Easy 2 Instruction Manual

Balancing the Easy 2

Before your first flight, it's important to check the balance of the
Easy 2. This is referred to as checking the C.G. (center of
gravity). Notice on the bottom of the wing where the red leading
edge trim meets the white. Where these two meet is where the
model should balance.
With the wing attached, place each index finger under the wing
(as shown) at the point where the red meets the white trim.
Note: you can feel where the two meet.
24
Now gently lift the Easy 2. If balanced correctly, the fuselage will
hang level. If the nose hangs low, it will be necessary to add
weight to the tail. If the tail hangs low, it will be necessary to add
weight to the nose. This can best be accomplished by using
stick-on weights, which are available at your local hobby shop.
Note: In most case, the Easy 2 will balance properly with no
additional weight needed.