Hangar 9 VRTF Easy 2 Instruction Manual page 17

Stage 4 — Installing the Tail
Step 20. Trial fit the tail assembly into the tail of the fuselage
as shown by sliding forward the tongue of the vertical fin into
the fuselage. Be sure the rudder pushrod goes on top of the
horizontal tail.
Step 21. Remove the tail assembly. There are two screw holes
on the rear plate. Put a washer on the screw and install the front
screw in the plate, through the hole on the bottom of the fuselage
to the top. Apply a drop of thread locker to the screw. Fit the tail
back into place, making sure the pushrod goes on top of the
horizontal tail, and screw the tail in place. Snug the screw firmly.
Now take the second screw, put a washer on it, apply a drop of
thread locker and insert it from the bottom, through the fuselage
and into the tail assembly. Secure tightly.
Make sure the tail is secure by tugging on the tail.
CONTINUED
17