Table of Contents
Advertisement
2
Hardware Installation
VGA Port
VGA
The system board can only be used with an analog video monitor.
Connect the monitor's 15-pin D-shell cable connector to the VGA
port (Blue) at location J3. If your monitor supports analog video but
does not have a 15-pin D-shell connector, see your monitor dealer
for the adapter or optional cable. After you plug the monitor cable
into the VGA port, gently tighten the cable screws to hold the
connector in place. Some monitors have a switch that chooses
between analog and TTL (or digital) operation. If your monitor has
such a switch, set it for analog.
BIOS Setting
Configure the onboard VGA in the Advanced Chipset Features
submenu of the BIOS.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
30
Advertisement
Table of Contents
