2
Hardware Installation
Front Panel Connector
HD-LED: Primary/Secondary IDE LED
This LED will light when the hard drive is being accessed.
RESET: Reset Switch
This switch allows you to reboot without having to power off the
system thus prolonging the life of the power supply or system.
SPEAKER: Speaker Connector
This connects to the speaker installed in the system chassis.
G-SW: Green Switch
This switch will allow your system to enter the Suspend mode.
G-LED: Green LED
This LED will not light when the system's power is on or when the
system is in the S3 (STR - Suspend To RAM) state. It will blink every
second when the system is in the S1 (POS - Power On Suspend)
state.
44
1 2
HD-LED
RESET
J21
SPEAKER
2 0
1 9
PWR-LED
G-LED
G-SW