Table of Contents
Advertisement
2
Hardware Installation
Floppy Disk Drive Connector
3 3
3 4
2
1
The floppy disk drive connector supports up to two standard floppy
disk drives. To prevent improper floppy cable installation, the
shrouded floppy disk header has a keying mechanism. The 34-pin
connector on the floppy cable can be placed into the header only if
pin 1 of the connector is aligned with pin 1 of the header.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the shrouded
floppy disk header (J22) on the system board and the other end-
most connector to the drive you want to designate as Drive A. If
you are connecting another drive (Drive B), install the middle
connector of the cable to the drive. The colored edge of the daisy
chained ribbon cable should be aligned with pin 1 of J22.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
of the BIOS. Refer to chapter 3 for more information.
35
Advertisement
Table of Contents
