Table of Contents
Advertisement
2
Hardware Installation
IrDA Connector
The IrDA connector at location J16 is for connecting an IrDA
module. Connect the cable connector from your IrDA module to
J16.
BIOS Setting
Configure IrDA in the Integrated Peripherals submenu of the BIOS.
Driver Installation
You may need to install the proper drivers in your operating system
to use the IrDA function. Refer to your operating system's manual or
documentation for more information.
38
IRRX
N. C.
Ground
VCC
IRTX
1
5
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable connector to the IrDA
connector according to their pin functions.
Advertisement
Table of Contents
