Rare Panel I/O Ports; Vga Port - DFI PIC-Q170 User Manual

Rear Panel I/O Ports
LAN 1 LAN 1 LAN 2 LAN 2 VGA
The rear panel I/O ports consist of the following:
• 2 LAN ports
•

1 VGA port

• 2 USB 3.0 ports
Chapter 2 Hardware Installation
Chapter 2
USB 1 USB 2
15
VGA Port
VGA
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure VGA in the Chipset menu ("North Bridge Configuration" submenu) of the BIOS. Refer
to chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
www.dfi .com