Updating Software; Orienting Your Interactive Flat Panel - SMART Board 6000 series User Manual

CHAPTER 5
MAINTAINING YOUR INTERACTIVE FLAT PANEL

Updating software

SMART Product Update (SPU) is included in the SMART software you installed to use your
interactive flat panel (see Installing SMART software on page 18). SPU periodically checks for
updates to the SMART software posted on the SMART website. You can configure SPU to prompt
users to install updates or to install updates automatically.
NOTE
If you didn't install SPU, you can download updates to SMART software from
smarttech.com/downloads.

Orienting your interactive flat panel

If the location of your touch is misinterpreted (the pointer appears a distance from the actual
contact), orient your interactive flat panel.
NOTE
You can use your finger or an interactive flat panel pen to orient your interactive flat panel.
To orient the interactive flat panel
1. Open SMART Settings (see Opening SMART Settings on the previous page).
2. Press Orient.
3. Press the red targets as they appear. Hold your finger or the tip of the pen at the center of
each target, and then lift the pen or finger. When you lift the pen or finger, the target moves to
the next orientation point.
IMPORTANT
Hold the pen perpendicular to the screen.
4. Continue until you've pressed all the targets.
The orientation window closes.
5. If this doesn't correct inaccurate touch, calibrate your interactive flat panel (see Calibrating
your interactive flat panel on the next page).
23 smarttech.com/kb/170642