Connecting Power; Connecting The Room Computer - SMART Board 6000 series User Manual

CHAPTER 3
CONNECTING POWER AND DEVICES
No. Connector
5 HDMI®

Connecting power

Connect the supplied power cable from the AC
power inlet on the bottom of the interactive flat panel
to a power outlet.
NOTE
Refer to your interactive flat panel's specifications for power requirements and power
consumption information (see Resources for decision makers on page 7).
Connecting the
room computer
Using USB and HDMI cables, connect the room
computer to the appropriate connectors on the
interactive flat panel.
NOTES
You can use the interactive flat panel with up to two USB-XT extenders.
l
If you use a CAT 5 USB extender, the maximum length of the Cat 5 cable is 52' (16 m).
l
Press the Input Select button
14 smarttech.com/kb/170642
Connects to
Room computer (video)
on the front control panel until the input source is HDMI.
Notes (if any)
The HDMI cable should be HDMI 1.4
compliant and no longer than 16' 5"
(5 m).
For more information, see below.