Configuring A 2104 To The Using System; Unconfiguring A 2104 From The Using System; Web Support Page; Related Publications - IBM 2104 DL1 Installation Manual

Expandable storage

Table of Contents

The cron requires a script. To create this script, generate a file named

run_ses_healthcheck in directory /usr/lpp/diagnostics/bin. The contents of the file must

be:

#!/bin/ksh

#Name: run_ses_healthcheck

#Location: /usr/lpp/diagnostics/bin

#Function: SCSI SES hourly healthcheck

/usr/sbin/lsdev -Cc container -t ses -s scsi -F name -S available |

Note: Although, because of page width, the final line of the contents is shown here

Give the following command so that the script can be run:

chmod 544 /usr/lpp/diagnostics/bin/run_ses_healthcheck

Configuring a 2104 to the using system

Use the cfgmgr command to configure or reconfigure a 2104 to the using system.

To remove a 2104 from the using system, use the following command:

rmdev -l [enclosurenumber] -d

where [enclosurenumber] is the enclosure device that was generated by the cfgmgr

command (for example, [ses0], [ses1], [ses2]).

Remove the ses_healthcheck job from the system cron table.

You can find the web support page at:

http://www.rs6000.ibm.com/support/

v Diagnostic Information for Micro Channel Bus Systems, SA23-2765

v Diagnostic Information for Multiple Bus Systems, SA38-0509

v Site and Hardware Planning Information, SA38-0508

v Adapters, Devices and Cable Information for Micro Channel Bus Systems,

SA23-2764

IBM Expandable Storage Plus: 2104 Model DL1 Installation Guide

/usr/bin/xargs -n1 -i /bin/nice --10 /usr/lpp/diagnostics/bin/diagela -t {}

split between two lines, you must enter it all on one line.

Table of Contents