Preparing The Rs/6000 Rack (System Or Expansion) - IBM 2104 DL1 Installation Manual

Preparing the RS/6000 Rack (System or Expansion)

Notes:
1. If you are installing the 2104 disk enclosure into an empty rack, install it into the
lowest available position so that the rack does not become unstable.
2. If you are installing more than one 2104 disk enclosure into the rack, start at the
lowest available position, and work upward.
3. You might need to remove the rack power distribution unit before you install the
support rails (see the Installation and Service Guide, or equivalent, for the rack).
1. Find the two support rails ( 5 in Figure 1 on page 4) that are supplied with the
2104.
2. The 2104 Model DL1 is three Electronics Industries Association (EIA) units high.
Using the preinstallation planning information, or other relevant information,
determine where you are going to locate the 2104 Model DL1 in the rack.
3. Refer to the EIA markings on the rack and decide where you are going to install the
support rails. If appropriate, allow for possible future installation of other disk
enclosures.
Installing a 2104 Model DL1
5