Field Service Ver. 1.0 May 2008
[2]
13. Remove the 1st image transfer pressure/retraction clutch assy.
See the steps 1 to 2 on P.88 "1st image transfer pressure/retraction clutch".
7.3.18
Scanner unit
1. Remove the rear cover.
See P.50
[1]
[1]
[2]
[1]
[1]
[1]
A00FF2C059DA
[1]
[2]
[1]
A0FDF2C013DA
[3]
A0FDF2C045DA
12. Remove seven screws [1], and
remove the driving unit [2].
NOTE
• When installing the driving unit
assy, take care not to damage or
soil the gears.
2. Remove seventeen screws [1], and
remove the board protective shield
[2].
3. Disconnect five connector [1], and
remove the screw [2] of the ground
terminal.
4. Pull out the harnesses from the
metal plate [3].
7. Other
73