Konica Minolta magicolor 4690MF Service Manual page 114

Field Service Ver. 1.0 May 2008
[2] [1]
[4]
[3]
[1]
< 0.1mm
11. To reinstall, reverse the order of removal.
A0FDF2C044DA
[3]
[2]
A0FDF2C089DA
<3> Insert the drawing up transporta-
tion assy shaft [1] into the rear
mounting hole [2].
<4> Insert the connecting part [3] of
the drawing up transportation
assy into the rear gear slot [4].
10. While pushing the positioning protru-
sion [1] of the drawing up transporta-
tion assy against the housing, fix the
assy with one screw [2].
NOTE
• Check that the two drive gears [3] of
the drawing up transportation assy
are engaged.
• Use a 0.1 mm piece of a thickness
gauge to check the gap between the
positioning protrusion [1] and the
main body frame. Make sure that
the piece of the thickness gauge
cannot pass through the gap.
(A transparency can replace the
thickness gauge.)
• Check that the shield sheet which
confirmed in step 4, is well
grounded onto PH unit base plate at
malt of drawing up transportation
assy.
7. Other
71