Configuring The Umts Interface; (Help) - Teldat Router User Manual

3. Configuring the UMTS Interface

The UMTS interface as such is an AT commands interface
There are certain commands which are common for all the device's interfaces. These commands are
described in the manual on configuring common interfaces (Dm 772-I Common Configurations for
Interfaces).
The available programming commands are as follows:
Command

? (HELP)

ADDITIONAL-CONTROL-COMMAND
ALWAYS-ATTACHED
DISABLE
ENABLE
FRAME-SIZE
NO
PIN
SPEED
UMTS
WAIT-TIME
EXIT
3.1. ? (HELP)
Displays a list of the available commands or their options.
Syntax:
umts2/0 AT config>?
Example:
umts2/0 AT config>?
accessibility-control
always-attached
disable
enable
frame-size
no
pin
speed
umts
wait-time
exit
umts2/0 AT config>
Functions
Lists the available commands or their options.
Configures the connectivity control.
Controls the module attach/detach to the network.
Disables functionalities.
Enables functionalities.
Configures the base interface frame size.
Permits you to configure default values or negate a
command.
Programs the PIN number for the SIM module used.
Programs the interface speed.
Permits
parameters.
Configures the physical connection maximum wait
time.
Returns to the configuration menu.
Set GPRS accessibility control
In PDP context disconnection not perform detach
Disable some features
Enable some features
Set frame size
Set default config
Set PIN number for internal Module
Set speed
UMTS configuration
Set maximum connection time
Return to previous menu
TELDAT ROUTER– UMTS Configuration
II - 11
you to configure UMTS connection
Doc.DM757-I
Rev.10.60