Installing The Locking Pin; Further Accessories - Invacare Storm4 Service Manual

SERVICE MANUAL
9.7.2

Installing the locking pin

Requirements:
· 12 mm open-ended wrench
· Medium strength thread locking adhesive, for example Loctite 243
Note
Always install the locking in on the inside of the motor rocker. This way the risk of damage is
reduced.
·
Apply medium strength thread-locking adhesive to the thread of the locking pin.
·
Screw the locking pin, together with the washer (3) into the threaded hole (4) on the inner side
of the motor rocker (1).
·
Pull the head of the locking pin towards the rear and hold it in this position.
·
Tighten the locking pin using an open-end wrench.
9.8

Further accessories

Note
The installation instructions for additional accessories are available at your Invacare® specialist
supplier or directly from Invacare
172
®
.
®
Invacare - STORM
4