Replacing A Front Splash Guard - Invacare Storm4 Service Manual

SERVICE MANUAL
8.1.5

Replacing a front splash guard

WARNING: Danger of crushing!
The wheelchair is very heavy. Danger of injury to the hands and feet!
· Let a second person help you.
Danger of injury due to uncontrolled movement of the wheelchair!
· Switch the vehicle's power system off (ON-/OFF key).
· Engage the drive motors.
· Secure the vehicle against rolling away by placing wedges under the wheels.
Requirements:
· 4 mm Allen wrench
· 24 mm socket wrench
· 24 mm open-ended wrench
· Flat screwdriver
· Oblong wooden blocks, at least 14 x 14 x 30 cm
· Medium strength thread locking adhesive, for example Loctite 243
· Heat gun
·
Lift the wheelchair on one side and have a second person place a 14 cm high wooden block
underneath it, so that the front wheel is off the ground and can rotate freely.
·
Remove the front wheel, as described in chapter 8.8.1.
Removing the splash guard:
·
Loosen and remove the four hexagon socket head screws (2) together with the washers.
·
Replace the splash guard (1).
Installing a splash guard:
·
Assemble the parts in reverse order.
42
®
Invacare - STORM
4