Replacing Conventional Armrest Pads; Using/Installing/Adjusting Locking Cantilever Arms; Using Locking Cantilever Arms - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

Replacing Conventional
Armrest Pads
NOTE: For this procedure, refer to
FIGURE 7.4.
1. Remove the mounting screws that
secure the existing armrest pad to the
armrest assembly.
2. Install new armrest pad and securely
tighten with the existing mounting
screws.

Using/Installing/Adjusting Locking Cantilever Arms

Using Locking Cantilever Arms

NOTE: For this procedure, refer to FIGURE 7.5 on page 45.
1. Push the locking mechanism actuator towards the front of the wheelchair.
2. While holding the locking mechanism actuator, pull up on the cantilever arm towards
the rear of the wheelchair.
NOTE: If necessary, the locking mechanism in the cantilever arm can be repositioned so the
cantilever arm will open down instead of up. For this adjustment, contact a qualified technician.
3. To lock the cantilever arm, push down until there is an audible click.
4. Pull up on the cantilever arm to make sure it is locked in place.
Part No 1125027
Rear of
Wheelchair
Push
Locking
Mechanism
Actuator
FIGURE 7.5 Using Locking Cantilever Arms
45
Armrest
Assembly
Mounting
Screws
FIGURE 7.4 Replacing Conventional
Armrest Pads
Front of Wheelchair
Cantilever Arm
SECTION 7—ARMS
Armrest Pad
® ™
Solara /Spree GT