Fitting The Handlebar - Invacare Storm4 Service Manual

®
Invacare - STORM

8.17.6 Fitting the handlebar

Requirements:
· 4 mm Allen key
·
Loosen and remove the four Allen screws (3) on the plastic cover.
·
Remove the plastic cover (2).
·
Remove the covers on the washer recesses (5).
·
Arrange the handlebar (1) on the back section in such a way that the boreholes coincide with
the tapped holes in the back section.
·
Fit the four Allen screws (4) incl. the washers (5) and tighten the screws.
·
Refit the plastic cover.
·
Refit the six Allen screws (3) and tighten them.
4
SERVICE MANUAL
151