Installing Locking Cantilever Arms; Adjusting Locking Cantilever Arm Height - Invacare Solara 3G User Manual

11.5 Installing Locking Cantilever Arms

 When removing the locknuts and washers from the cantilever arm assembly, leave the top hex bolt, coved washers and
spacer (between adjustment plate and cantilever arm) in place.
1. Slide the partially assembled cantilever arm assembly with mounting hardware through the back cane. Make sure the adjustment plate is towards
the inside of the wheelchair..

This includes top hex bolt, coved washers and spacer (between adjustment plate and cantilever arm.
2. Slide the bottom hex bolt (w/coved washer) through the
adjustment plate and back cane.
3. Securely tighten the cantilever arm to the wheelchair with two
locknuts and washers.
4. Adjust the angle of the cantilever arm, if necessary. Refer to
Adjusting the Locking Cantilever Arm Angle on page 96.

Adjusting Locking Cantilever Arm Height.

When removing the locknuts and washers from

the cantilever arm assembly, leave the top hex
bolt, coved washers and spacer (between
adjustment plate and cantilever arm) in place.
1. Remove the two locknuts and washers securing the cantilever arm
assembly to the back cane.
2. Remove the cantilever arm assembly with hardware from the back
cane.
3. Perform STEPS 1-4 in Installing Locking Cantilever Arms. on
page 95 to reposition the arm at the desired height.
Part No 1154295
.
Adjustment
FIGURE 7
95
Spacer
Coved
Washers
Plate
Actuator
Top Hex Bolt
and Coved
Washer
Bottom Hex Bolt
Installing Locking Cantilever Arms. - Adjusting Locking
Cantilever Arm Height.
Invacare® Solara®3G/Spree 3G Wheelchair
11 ARMS
Locknuts
Washers
Back Cane
Cantilever Arm