Table of Contents
Advertisement
Selecting the Unit Type and What You Want to Configure
!
To set the unit function type
1.
In the Configuration Source screen, select one of the following function types
displayed in the Unit Type drop down list:
MCU (single station MCU–323)
"
MCU Distributed (distributed MCU–323)
"
MP Dedicated (dedicated MP)
"
2.
From the Source drop down list, select the configuration source file. If this is a first
time configuration, select Current.
3.
Click Unit Setup to proceed with configuration. Refer to the section corresponding to
the Unit Type you selected for further configuration instructions.
Note
When configuring a unit to function as an MCU-323 with a built–in Gatekeeper, the
Gatekeeper must be configured prior to the MCU-323. Refer to Configuring the Built–in
Gatekeeper for instructions.
To configure the unit as a ...
Single Station MCU-323
Distributed MCU-323
Dedicated MP
The table below outlines the configuration screens contained in Unit Setup for each of the
function types, and points to where each screen is described.
Proceed to ...
Configuring a Single Station MCU-323
Configuring a Distributed MCU-323
Configuring a Dedicated MP
6-1
Advertisement
Table of Contents
