moon 400M Owner's Manual
  1. Manuals
  2. Brands
  3. moon Manuals
  4. Amplifier
  5. 400M
  6. Owner's manual

moon 400M Owner's Manual

Mono moon series
Hide thumbs Also See for 400M:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Owner's Manual
MOON Series
400M
Mono Power Amplifier

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 400M and is the answer not in the manual?

Questions and answers

Related Manuals for moon 400M

Summary of Contents for moon 400M

  • Page 1 Owner’s Manual MOON Series 400M Mono Power Amplifier...

  • Page 2: Important Safety Instructions

    MOON 400M Mono Power Amplifier Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block ventilation openings. Install in accordance with the manufacturer’s instructions.
  • Page 3 To prevent shock hazard, all three connections must ALWAYS be used. Connect the MOON 400M only to an AC source of the proper voltage; Both the shipping box and rear panel serial number label will indicate the correct voltage. Use of any other voltage will likely damage the unit and void the warranty AC extension cords are NOT recommended for use with this product.

  • Page 4: Table Of Contents

    MOON 400M Mono Power Amplifier Table of Contents Congratulations ..........5 Unpacking............5 Introduction ............. 6 Installation & Placement ........6 Rear Panel Layout ..........7 Connecting the 400M......... 8 Balanced Operation ........... 8 Operating the 400M........... 9 Specifications ..........10 www.simaudio.com...

  • Page 5: Congratulations

    MOON amplifiers are so musically satisfying. The performance of your 400M will continue to improve during the first 300 hours of listening. This is the result of a “break- in” period required for the numerous high quality electronic parts used throughout this amplifier.

  • Page 6: Introduction

    The 400M uses a large toroidal transformer in its power supply; even though it is well shielded, you should not place this amplifier too close to source components sensitive to EMI, such as turntables, phono preamplifiers and CD Players.

  • Page 7: Rear Panel Layout

    MOON 400M Mono Power Amplifier Rear Panel Layout Figure 1: Rear panel of Moon 400M Mono Amplifier The rear panel will look similar to Figure 1 (above). There is one balanced (differential) input on an XLR connector and one unbalanced (single-ended) input on a RCA connector. No switch to toggle from balanced mode to single-ended mode exists;...

  • Page 8: Connecting The 400M

    “Balanced Operation” on for further information. Do not connect cables to both the XLR input and RCA input at the same time. Damage to both the 400M and the connected equipment can result that is not covered by warranty.

  • Page 9: Operating The 400M

    If your 400M still doesn’t power up, turn off the main power switch and check the AC fuse. If the fuse appears OK, put it back in its socket and then try to power up again the usual way. If the fuse is blown, replace it with a fuse of the same rating, and repeat the above process.

  • Page 10: Specifications

    Jack......... 3.5mm microphone jack Input Impedance....1kΩ Current Consumption..12mA NOTE: In the event that you require the RS-232 codes for your MOON 400M, please contact Simaudio Ltd. directly by either email (service@simaudio.com) or by toll-free telephone (877-980-2400). Fuse Replacement: For the 120V version use a 8A fast blow (3AG size).

Table of Contents