Video Program Selection - Novra S300 User Manual

Figure 9 - Content Configuration Screen

4.3.1.1 Video Program Selection

Selecting the Video Program Selection tab will bring up the screen shown above in Figure . The
purpose of this screen is to enable the operator to configure the S300 to receive an MPEG Video program
and assign it to a multicast IP address so that it can be forwarded onto the receiver LAN. The process to do
this is quite simple – enter the program ID and the multicast IP address/port and select Apply.
The video selection screen is split into three sections. The right-most screen displays the Program Guide
which is parsed out from the Transport Stream SI tables by the S300. Occasionally it takes a few seconds for
this part of the screen to be updated. The Refresh button below the Program Guide may be used to
manually refresh the Program Guide contents.
Confidential and Proprietary 27 of 50
Version: 2.02