Novra S300 User Manual page 11

You must also ensure that the network settings of the S300 make it accessible from the Windows
management PC. The IP address of the device and the IP address of the management station must
reside on the same subnet, or there must be a route that connects both of them through a router. If
this is NOT the case, you will be prompted with the Change IP Address Screen as shown below in
Figure 3. You will need to change the IP address of your management PC to be on the same subnet
as the receiver (in this case, change your PC IP address to: 192.168.0.xxx, where xxx is not equal to
11).
3- Note: If there is an S300 receiver accessible on your network, but not on your local LAN you can still
configure it as if it were on your local LAN. In the Managed List section of the screen above, enter
the IPE address of the receiver you wish to configure in the IP field. You can also provide an optional
name beside it if you wish. Once the IP address is entered, click Add to add the IP address to the
Managed List. Now double click the IP address you just added to run the Configure Application on
the receiver. You can use the Add, Delete, and Delete All buttons to add/remove entries in the
Managed List.
4- Once you have successfully connected to your receiver, you will be prompted to enter a password
(see Figure 4 below). The default password that you can use with your new receiver is: Novra-S2.
Version: 2.02
Figure 3 – Change IP Address Screen
Confidential and Proprietary 11 of 50