Novra S300 User Manual page 15

ii. IP Data buttons enables the operator to configure the receiver to receive Multi-
iii. Programs button group (Content and PAT) provides standard and advanced
iv. Control button group provides an additional configuration item that includes
NOTE:
and re-distribute IP data, while the Porgrams function is used to configure the
to S300 and re-distribute video programs. The Program function may not be
available on your receiver model.
3. The middle bar of this screen displays the IP address and MAC address for the selected
S300 being configured.
4. Status information on the operation of the S300 is provided in the lower part of the screen.
This status includes:
i. Status – Turns green when the status packets are being successfully received from
ii. Signal – Turns green when the receiver detects an input RF signal at the selected
iii. Data – Turns green when the S300 has achieved data lock. This means that the
NOTE:
S300 will blink at a ½ second interval if data is being processed and forwarded
by the S300.
iv. LNB – Turns green when the LNB is turned on and is gray when the LNB is turned
Version: 2.02
Protocol Encapsulation (MPE) data and pass/map this data onto the LAN.
features enabling the operator to receive MPEG transport stream packets and pass
these packets to Multicast IP addresses on the LAN. If the PAT button is grayed out,
this feature is not available on the S300 model.
Reboot.
- Typically the IP Data function is used to configure the S300 to receive
the S300 by the S300 console.
frequency. This matches Signal LED on the front of unit.
receiver is able to recover all the digital timing from the input signal and is receiving a
valid DVB transport stream. This does NOT match the blue data LED on the front of
the S300.
- S300 DATA LED – The blue data LED on the front face plate of the
CA Module – Turns yellow when the S300CA detects a valid CAM in the PCMCIA
slot. Turns green when the S300CA detects a valid Program Association Table
(PAT) on the incoming stream. If the LED is grayed out, this feature is not available
on your receiver model.
off. The LNB status LED will also turn red if there is a DC short present on the RF
connector input.
Confidential and Proprietary 15 of 50