Raw Pid Selection - Novra S300 User Manual

4.3.1.4

Raw PID Selection

The Raw PID Selection Tab enables the receiver to be configured to pass raw MPEG PID's to a multicast IP
address, or to pass the full received Transport Stream to a single multicast IP address.
The following describes the configuration items for this tab:
1. Destination: Use this edit box to enter the multicast IP address and port number.
2. PID - Add: Use this edit box to manually add Raw PID's to the multicast transport stream.
3. Delete PID's: Use this edit box to remove Raw PID's from the multicast transport stream.
4. Clear List: Select this button to clear the Raw PID list.
5. Add Raw Program: After configuring your Raw PID's, select this button to apply the configuration to
the S300.
6. Modify Raw Program: After making changes to your Raw PID's, select this button to update the
selected PID's.
7. Delete Raw Program: Select this button to delete your selected Raw PID's.
8. Delete All Programs: Select this button to delete all Raw PID's.
The Show All. checkbox at the bottom of the Programs Selected pane can be used to show just the
configured Raw PID entries or to show all the configured entries.
The entry of these RAW PID's (100, 1000, 1020) in the Program list does not show any color highlighting
because the receiver does not have any information regarding the assignment of these PID's to a program.
Version: 2.02
Confidential and Proprietary 34 of 50