Mpe Program Selection - Novra S300 User Manual

4.3.1.2

MPE Program Selection

The MPE Program Selection tab allows the user to configure the S300 to receive MPE programs. To add an
MPE program, the user enters the Program ID (or SID) into the Program ID text box and selects Add MPE
Program. Similarly, to remove an MPE program, the user selects the program and clicks Remove MPE
Program.
The Show All. checkbox at the bottom of the Programs Selected pane can be used to show just the
configured MPE Program entries or to show all the configured entries.
As was described in Section 4.3.1.1 above, detailed information on a given program (Program 1010, in this
case) may be displayed by right clicking over the Program and selecting Show Program Info. The
Program 1010 information pane is also shown in the figure below.
Version: 2.02
Figure 12 - MPE Program Selection Screen
Confidential and Proprietary 32 of 50