Novra S300 User Manual page 25

3) New IP: The destination multicast IP address that the original multicast IP address is mapped to. It is
possible to map multiple Original IP addresses to a single New IP address. Note: this IP address must be
a multicast IP address.
4) Mask: The subnet mask is applied to the Original IP address to create a range of IP addresses that are
mapped to the new destination IP address.
5) TTL: Setting the Time To Live (TTL) value to non-zero causes the TTL field in the IP header to be
replaced with this value. The default setting is zero.
6) Action: The S300 shall perform the following packet forwarding options based on this value. The default
setting is no rule.
a) No Rule - rule entry is not applied to the packet
b) Normal - packet is forwarded based on the IGMP setting
c) Forward - packet is always forwarded
d) Discard - packet is always discarded
7) Add Rule: Adds the rule as defined by the mapping table fields (entries 2-6 above) into the mapping
table. Note: The mapping table fields may be populated by double clicking on a selected mapping table
entry and may be then edited and added to the mapping table by clicking the Add Rule box.
8) Change Selected Rule: The operator may load any rule into the mapping table fields (2-6 above) and
edit any of the parameters as needed. Clicking the Change Selected Rule button will modify the selected
rule with the edited updates.
9) Delete: Will delete any selected entry in the mapping table
10) Delete All: Will delete all entries in the mapping table
11) Apply: Will apply the mapping table to the receiver. This box must be selected for the mapping table
changes to take effect
12) Exit: Will exit back to the S300 Configuration Application main screen
Version: 2.02
Confidential and Proprietary 25 of 50