Novra S300 User Manual page 16

v. Signal Strength – Provides a graphic indication of the signal power at the input of
vi. Carr. Freq. – Provides the I/F carrier frequency in Mhz and the difference between
vii. Sym. Rate – Provides the receiver symbol rate.
viii. ModCod/Coding Rate : Depending on the mode of operation (DVB-S vs. DVB-S2),
ix. LDPC BER/BER: Depending on the mode of operation (DVB-S vs. DVB-S2), this
x. Uncorrectables –. The number of uncorrectable packets that were processed by the
xi. C/N – Provides the receive signal Carrier-to-Noise ratio (C/N).
5. Minimize – To the system Tray
6. Close – Close the S300 Console
7. Traffic Counters – The S300 provides a number of traffic counters that are useful in
determining the health and operation of the receiver.
i. Total Ethernet Packets Sent: This counter accumulates the total number of packets
ii. Total Ethernet packets received: The number of Ethernet packets that the S300
iii. Ethernet Receive Errors: The number of errors that occurred during the reception of
iv. DVB Packets Accepted: The number of DVB packets that the receiver accepted and
v.
NOTE:
You can use the reset buttons to rest the counters.
Version: 2.02
the receiver.
the desired IF frequency and the tuned value.
this status value will change as follows:
1. MODCOD (DVB-S2): Provides the modulation rate and coding rate of the
input stream; this number is only valid when the receiver is locked
2. Coding Rate (DVB-S): Indicates the Viterbi code rate of the input stream.
This number is only valid when the receiver is locked.
status value will change as follows
1. LDPC BER (DVB-S2): Provides a count of the Low Density Parity-Check
(LDPC) Bit Error Rate (BER). This number is a measure of the input signal
quality
2. BER (DVB-S): indicates the receiver Viterbi Bit Error Rate (BER) of the input
stream. This number is a measure of the signal quality
demodulator section of the receiver. The counter accumulates and can be reset
using the Reset button located beside the Uncorrectables field.
being sent from the Ethernet port on the receiver.
received on the Ethernet interface.
Ethernet packets.
processed.
MPE Packets Processed: The number MPE data packets processed by the S300.
The counters will keep accumulating as long as the window is open.
Confidential and Proprietary 16 of 50