Connecting Electricity Supply; Air Lubrication; Torque Reaction - norbar PNEUTORQUE PTM series Operator's Manual

Connecting Electricity Supply

Attach the power supply extension lead between the power tool lead (Figure 1-F) and the power supply (Figure
1-G).
Fit the mains power lead to the power supply (Figure 1-G). The display and LED's will illuminate for a short
time.
TIP: If the power lead has no plug fitted, wire as follows:
BROWN-LIVE

Air Lubrication

The tool must be used with oil lubrication in the supplied air, this is achieved by using a Lubro Control Unit (not
supplied).
Set the air lubrication:
a. Fill Lubro Control Unit with hydraulic oil (Shell Tellus S2M 32 or equivalent good quality hydraulic oil).
b. Ensure the tool drive square is free to rotate.
c. Run the tool by pressing the trigger.
d. Adjust the Lubro Control Unit for maximum tool air pressure. Air pressure
is shown on the gauge.
TIP: Using maximum air pressure will give maximum tool speed.
e. Adjust Lubro Control Unit to supply 6 drops of oil per minute.
f. Release trigger.
IMPORTANT: THE WRENCH MUST BE FREE RUNNING WHILE ADJUSTING THE AIR PRESSURE
TO GIVE THE CORRECT SETTING.
See Lubro Control Unit handbook for more details.

Torque Reaction

The reaction bar ensures all reaction forces are contained, so torque reaction is not passed back to the
operator. Several reaction bar types are available.
Fit reaction bar as detailed below:
Tool Model Reaction Bar Type
Cranked reaction bar (standard)
Single sided reaction plate (option)
Double sided reaction plate (option)
PTM
Nose Extension (option)
PTME Nose Extension (Standard)
8
BLUE-NEUTRAL GREEN / YELLOW-EARTH
Fitting Instructions
Fit reaction bar / plate (Figure 1-D) over the
drive square to engage reaction splines.
Secure with circlip supplied.
Fit as instructions supplied with nose extension.
Factory fitted, not removable.