Table of Contents
Advertisement
Torque Units - Change
Press UP or DOWN to change displayed
Target
function if a
is active (see pages 7, 8 & 12).
TIP:
Units that have been disabled in (SETUP - Units) will NOT be shown. See page 18.
Zero Display Offset
Exercise the NorTronic
Press the ZERO button to
the wrench capacity.
TIP:
Zero the NorTronic
of the tool is not affecting the reading. If the displayed reading does not zero, increase the
reading by applying and maintaining a small torque (<3%) and then press the ZERO button.
Remove the torque and press the button again.
# of Saved Readings
Every time a
Test Result
incremented. This is reset when the
Sleep
®
The NorTronic
will
Sleep
specified in
Tool SETUP– Sleep
a) A button has been pressed.
The Torque reading has changed by more than
b)
TIP:
The NorTronic
Resume from Sleep (Gyroscope drift calibration)
To wake the NorTronic
gyroscope drift calibration. The Gyroscope drift calculation will also be done if the temperature changes by
more than 3 degrees. This is necessary to ensure the angle measurement is accurate.
5 second countdown to the Gyroscope drift calculation.
WARNING:
Torque
®
in required direction of use.
Zero
both the
Torque & Angle
®
in the vertical position with the ratchet head removed, so that the weight
is saved to the NorTronic
Tool Target
if any of the events listed below have
(see page 19 for more information):
®
can be forced to sleep at any time by pressing the
®
, press any button. After the display of the Norbar logo the NorTronic
Do Not Move
PLACE THE TOOL ON A FLAT LEVEL SURFACE AND DO NOT MOVE
BEFORE "CALCULATING" IS DISPLAYED.
Units. The UP button has a different
values when the Torque is below
®
memory, the
Reading #
has been changed.
not
happened during the time period
2%
of the wrenches capacity.
Start 5
3%
of
(bottom left of display) is
button for 2 seconds.
®
will perform a
9
Advertisement
Table of Contents
