Daikin Skyair FHC35K Service Manual page 37

Method of Field Set (Reset after Maintenance Inspection/Repair)
After completing setting, seal off the opening of the address switch and the MAIN/SUB switch with the
attached sealing pad.
Setting The
<Setting from the remote controller>
Address of
1. Hold down the "
Wireless Remote
Controller
2. Press the "
(It is Factory Set to
"1")
3. Press the "
4. Press the "
5. Hold down the "
26
" button and the "
FIELD SET MODE. (Indicated in the display area in the figure at right).
" button and select a multiple setting (A/b). Each time the button is pressed the
display swicthes between "A" and "b".
" button and "
Address can be set from 1 to 6, but set it to 1 ~ 3 and to same address as the receiver. (The receiver
does not work with address 4 ~ 6.)
" button to enter the setting.
the normal display.
<In Case of FUY Model>
" button for at least 4 seconds, to get the
" button to set the address.
" button for at least 1 second to quit the FIELD SET MODE and return to
Si-71A
Explanation of Field Set