Cleaning Transmission Strainer; Replacing Fuel Filter; Every 500 Hours; Adjusting Engine Valve Clearance - Kubota ZG222A-AU Operator's Manual

66 PERIODIC SERVICE
BCleaning Transmission Strainer
When changing the transmission fluid, disassemble and
rinse the strainer with nonflammable solvent to completely
clean off filings.
Check O-rings, replace if damaged, cracked or hardened.
When reassembling be careful not to damage the parts.
(1) Transmission strainer
(2) O-ring
(3) Center case cover
A Since the fine filings in the oil can damage the
precision component parts of the hydraulic system, the
end of the suction line is provided with an oil strainer.
BReplacing Fuel Filter
Consult your local KUBOTA Dealer for this service.

EVERY 500 HOURS

BAdjusting Engine Valve Clearance
If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.

EVERY AFTER 1000 HOURS

BCleaning Combustion Chamber
If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.

EVERY 1 YEAR

BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "PERIODIC SERVICE" section.)
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
[How to remove the secondary element]
1. While turning slightly, pull out the secondary element.
(1) Secondary element