Checking Tire Pressure; Inflation Pressure - Kubota ZG222A-AU Operator's Manual

(1) Air intake screen
(2) Engine dust plate
(3) Dust cover
(4) Bottom clean lever
6. If the dust or chaff has accumulated air intake area,
clean them completely by pushing down the bottom
clean lever several times.
When using the bottom clean lever, remove the lever
from the bracket.
After cleaning, make sure that the lever is replaced in
place.
(A) "PUSH DOWN"
(B) Bracket
BChecking Tire Pressure
To avoid serious injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Inflation pressure in front tires rises quickly
when using compressed air.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Do not use tires larger than specified.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
Tire sizes
13 x 5.0 - 6,
Front
4PR Rib
23 x 10.5 - 12,
Rear
4PR Turf
(1) Ground
PERIODIC SERVICE
Recommended Inflation
Max. Pressure
270 kPa
(2.8 kgf/cm , 40 psi)
140 kPa
(1.4 kgf/cm , 20 psi)
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
45