Operating The Machine; Operating New Machine; Changing Lubricating Oil For New Machines; Engine Break-In - Kubota ZG222A-AU Operator's Manual

18

OPERATING THE MACHINE

OPERATING THE MACHINE

OPERATING NEW MACHINE

How a new machine is operated and maintained
determines the life of the machine.
A new machine just off the factory production line has
been, of course, tested, but the various parts are not
accustomed to each other, so care should be taken to
operate the machine for the first 50 hours at a slower
speed and avoid excessive work or operation until the
various parts become "broken-in." The manner in which
the machine is handled during the "breaking-in" period
greatly affects the life of your machine. Therefore, to
obtain the maximum performance and the longest life of
the machine, it is very important to properly break-in your
machine. In handling a new machine, the following
precautions should be observed.
BChanging Lubricating Oil for New
Machines
The lubricating oil is especially important in the case of a
new machine. The various parts are not "broken-in" and
are not accustomed to each other; small metal grit may
develop during the operation of the machine; and this may
wear out or damage the parts. Therefore, care should be
taken to change the lubricating oil a little earlier than
would ordinarily be required.
For further details of change interval hours.
(See "SERVICE INTERVALS" in "MAINTENANCE"
section.)
BEngine Break-in
After the first 50 hours of operation, change the engine oil
and filter. (See "EVERY 100 HOURS" "EVERY 200
HOURS" in "PERIODIC SERVICE" section.)
BMachine Break-in
After the first 400 hours of operation, change the
transmission fluid. (See "EVERY 400 HOURS" in
"PERIODIC SERVICE" section.)
After the first 50 hours of operation, change the oil filter
cartridge. (See "EVERY 200 HOURS" in "PERIODIC
SERVICE" section.)
To avoid serious injury or death:
A Do not operate the mower without the deflector
shield in the down position.
To avoid serious injury or death:
A The machine relies upon the engine driven
transmission for speed, direction and motion
control. If the engine is not running, the
machine cannot be driven or controlled.
If the engine stops when operating on a slope,
apply the parking brake immediately to prevent
machine runaway.
A Do not allow any person other than the driver to
ride on the machine.
A Do not drive the machine close to the edges of
ditches or banks which may collapse under the
weight of the machine, especially when the
ground is loose or wet.
A When turning the machine, be sure to reduce
the travel speed and operate motion control
levers carefully.
A To avoid tip over, operate across slopes, not up
and down. Avoid sudden starts and stops on
slopes. Slow down, and use extra caution when
changing direction on a slope.
Park the machine on a firm and level surface.
A Watch where you are going at all times. Watch
for and avoid obstacles. Be alert at curbs, near
trees, and other obstructions and hidden
hazards.
A Do not mow near drop-offs, ditches or
embankments. The mower could turn over if a
wheel is over the edge of cliff or ditch, or if an
edge caves in.
A Do not drive machine on streets or highways.
Watch for traffic when you cross roads or
operate near roads.
A Look to the rear before and when backing.
Make sure the area immediately behind you is
clear of obstructions or holes and small
children. Use extra caution when machine is
equipped with Grass Catcher.
A Keep bystanders especially children and
animals away from the mowing area.
To avoid personal injury:
A Clear the work area of objects which might be
picked up and thrown by blades.
A Do not direct the opening of the chute at
bystanders or animals. Ejected objects may
cause injury. Plan your mowing carefully
before starting operation.
A Be sure to disengage the PTO and sit on the
operator's seat before starting the engine.