Every 200 Hours; Replacing Engine Oil Filter - Kubota ZG222A-AU Operator's Manual

60 PERIODIC SERVICE
If serial numbers of mower are as indicated below
RCK48P-222Z:30001 and above
RCK54P-227Z:30001 and above
1. To drain the used oil, remove the drain plug and oil
inlet plug with gauge at the gear box and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check plug port.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
5. After filling reinstall the check plug and oil inlet plug
with gauge securely.
(1) Drain plug
(2) Check plug
(3) Oil inlet plug with gauge
(4) Gear case
(5) Check plug port
(A) Oil level is acceptable within
this range.
(B) Oil level

EVERY 200 HOURS

BReplacing Engine Oil Filter
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil and the oil filter.
A Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
1. The oil filter must be changed every 200 service hours.
2. Apply a slight coat of oil onto the rubber gasket of new
filter.
3. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
4. After the new filter has been replaced, the engine oil
level normally lowers a little. Add engine oil to proper
level. Check for oil leaks around filter gasket.
A To prevent serious
replacement element of the recommended type must
be used. Use only a genuine KUBOTA filter or its
equivalent.
(1) Engine oil filter
damage to the engine,