Replacing Transmission Oil Filter Cartridge; Adjusting The Motion Control Lever Pivot - Kubota ZG222A-AU Operator's Manual

BReplacing Transmission Oil Filter
Cartridge
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil filter.
A Allow transmission
sufficiently; oil can be hot and may cause
burns.
1. The oil filter cartridge must be changed every 200
service hours.
(1) Oil filter cartridge
(1) Oil filter cartridge
2. Place an oil pan underneath the oil filter cartridge. (Do
not drain oil.)
3. Remove the oil filter cartridge by using the filter
wrench.
4. Apply a slight coat of oil onto the gasket of new filter.
5. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
6. After the new cartridge has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
case to cool down
(2) Gasket
A To prevent serious damage or premature failure to the
hydraulic system, use only a KUBOTA genuine filter.
BAdjusting the Motion Control Lever Pivot
To avoid personal injury:
A Be sure to stop the engine and set the parking
brake to "ON" before checking.
Proper lever free travel
1. Set the motion control lever in "NEUTRAL" position.
2. Slightly move the lever back and forth and measure
the free travel at the top of lever stroke.
3. If the proper free travel limits are exceeded, remove
the fender and retighten only the upper nut to specified
torque.
A If the motion control lever pivot bolt is maladjusted,
motion control may be difficult.
(1) Motion control lever
(2) Bolt, Nut
Tightening torque
PERIODIC SERVICE
2 to 15 mm (0.08 to 0.59 in.)
on the lever
(A) "FREE TRAVEL"
18.6 to 20.6 N-m
(1.9 to 2.1 kgf-m,
13.7 to 15.2 lbf-ft)
63