Inspecting And Cleaning Fuel Filter Bowl - Kubota ZG222A-AU Operator's Manual

80 STORAGE
5. After that, turn the carburetor fuel valve to the "STOP"
(CLOSE) position.
A Before adding fuel, make sure the carburetor fuel
valve is in the "STOP" (CLOSE) position. Turn the
carburetor fuel valve to the "RUN" (OPEN) position
before starting the engine.
(1) Carburetor fuel valve
(1) Carburetor fuel valve
(2) Drain port
(3) Fuel filter bowl
(A) "STOP" (CLOSE)
(B) "RUN" (OPEN)
(C) "DRAIN"
BInspecting and Cleaning Fuel Filter Bowl
Clean the fuel filter bowl before adding fuel to the engine.
To avoid serious injury:
A Never smoke nor use fire or naked flame during
inspection or cleaning.
A Mixing of foreign matter or water in the fuel might
cause a plugged filter element prematurely or cause
much water to accumulate on the bottom of the fuel
filter bowl.
A If water accumulates on the bottom of the fuel filter
bowl, clean the fuel filter bowl or replace it with a new
one.
C Inspecting and cleaning
1. Turn the carburetor fuel valve from the "RUN" (OPEN)
position to the "STOP" (CLOSE) position.
(1) Carburetor fuel valve
(2) Ring screw
(3) Fuel filter bowl
2. Loosen the ring screw and remove the fuel filter bowl.
3. Remove the filter element and wash it lightly by
dipping in gasoline.
contaminated element with a new one.
(A) "STOP" (CLOSE)
(B) "RUN" (OPEN)
(C) "DRAIN"
Replace any excessively