Cleaning Engine Oil Cooler Fins - Kubota ZG222A-AU Operator's Manual

10. Undo the rubber hook and open the air intake screen.
Remove the debris on the surface of the air intake area
by hand and blow off small debris with compressed air.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm , 30 psi).
Then clean them completely by pushing down the
bottom clean lever several times.
When using the bottom clean lever, remove the lever
from the bracket.
After cleaning, make sure that the lever is replaced in
place.
(1) Air intake screen
(2) Engine dust plate
(3) Dust cover
(4) Bottom clean lever
11. Install the cover with six bolts and then the fan cover
with two screws.
12. Install the muffler cover with four bolts.
13. Pull up the seat support rod and release the "LOCK".
14. Lower the seat slowly to lock.
15. Close the hood.
(A) "PUSH DOWN"
(B) Bracket
BCleaning Engine Oil Cooler Fins
[ZG227 only]
This engine is equipped with an oil cooler. The style of the
oil cooler is mounted on the blower housing. Pressure of
compressed air must be under 205 kPa (2.1 kgf/cm , 30
psi).
To avoid personal injury:
A Make sure the engine is cool enough to touch
before removing
components.
A Always shield eyes and a face from air deposits
and objects.
1. Stop the engine and apply the parking brake.
2. Loosen the two bolts for the engine oil cooler and
remove the connector.
(1) Oil cooler
(2) Bolt
(3) Connector
3. Pull out the engine oil cooler.
(1) Oil cooler
PERIODIC SERVICE
shrouds and
53
other