Adjustment; Motion Control Lever; Hst Neutral - Kubota ZG222A-AU Operator's Manual

ADJUSTMENT

MOTION CONTROL LEVER

To avoid personal injury:
A Park the machine on a firm and level surface.
A If it is necessary to run the engine in an
enclosed area, use a gas tight exhaust pipe
extension to remove the fumes.
A Always try to work in a well-ventilated area.
A Lift up and secure with jack stands or blocking
the rear of the machine, do not run the machine
while adjusting.
Remove rear wheels.
A Do not adjust only one of the following
adjustments; exclude "MOTION CONTROL
LEVER ALIGNMENT".
They are interlinked.
A If you feel you are unable to make the following
adjustments correctly and safely, please
contact your local KUBOTA Dealer.
A Right and left motion control levers can be adjusted
independently.
A This machine has a creep speed.
BHST NEUTRAL
1. Lift-up and secure with jack stands or blocking the rear
of the machine frame.
2. Remove both rear wheels.
3. Start the engine, and run at maximum speed.
4. Remove the lever guide.
5. Place the motion control lever in "NEUTRAL LOCK"
position.
6. Check that the lever is touching the front side of its
guide plate.
If the lever is not in the correct position, adjust the
speed control spring.
See "CREEP SPEED".
7. Remove the set knobs of seat frame, then raise and
latch the seat assembly.
8. Remove the connector from the seat safety switch,
and then temporarily install a jumper wire across the
terminals in the connector of the wiring harness.
To avoid personal injury:
A Do not operate the machine with a jumper wire.
9. Loosen the lock nut of the motion control rod.
Adjust the motion control rod until the rear axle rotation
stops.
10. Lengthen the rod by 1/2 turn and then tighten the lock
nut.
Place the motion control lever to the reverse position,
and move them to the forward slowly.
11. Place the lever in "NEUTRAL LOCK" position, and
check that the rear axle does not rotate.
If the axle does not stop rotating, adjust the "HST
NEUTRAL" again.
12. Adjust the other side "HST NEUTRAL" equally.
13. After adjustment, make sure to stop the engine
immediately.
(1) Guide plate
(2) Motion control lever
(1) Motion control rod
(2) Lock nut
(3) Beam plate
(4) Panel screen
ADJUSTMENT
(A) The lever is in contact
with plate.
71