Kubota ZG222A-AU Operator's Manual page 93

76 ADJUSTMENT
Less than 6 mm (1/4 in.)
Front-to-Rear
Front side must be lower
adjustment
C Adjusting level (Front-to-Rear)
1. Raise up the mower deck to the transport position.
(Also the top end).
2. Turn the cutting height set dial to the 3 in. cutting
height position.
3. Place 51 mm (2 in.) height wood blocks under each
side of the mower deck.
Anti-scalp rollers must not rest on the wood block.
4. Lower the mower deck.
5. Loosen the lock nuts of the front side of the machine.
6. Adjust the cutting height fine tuning bolts to set 76 mm
(3 in.) height.
Both front side bolts must be adjusted.
7. Lock the nuts.
8. Adjust the other side equally.
A The difference between both measurements should
be less than 6 mm (1/4 in.).
Front side must be lower than rear side.
9. Check the front-to-rear level and if it is not level,
adjustment is necessary.
(1) Cutting height fine tuning bolt
(2) Lock nut
than Rear side.