Creep Speed; Maximum Speed (Forward); Motion Control Lever Alignment - Kubota ZG222A-AU Operator's Manual

72 ADJUSTMENT
BCREEP SPEED
1. Lift-up and secure with jack stands or blocking the rear
of the machine frame.
2. Remove both rear wheels.
3. Start the engine, and run at maximum speed.
4. Place the lever in "NEUTRAL" position.
5. Pull the lever to the reverse maximum position and
release the lever.
6. Measure the axle rotation.
7. Loosen the lock nut and adjust the creep speed control
bolt length so that the axle rotation is between 8 to 10
revolutions per minute. (Do not change spring length
L=55 to 56 mm (2.17 to 2.2 in.))
8. Tighten the lock nut.
9. Check the axle creep rpm again.
If it is not correct, adjust again.
10. Adjust the other side "CREEP SPEED" equally.
11. After adjustment, make sure to stop the engine
immediately.
(1) Lock nut
(2) Creep speed control bolt
(1) Motion control lever
(2) Guide plate
(L) 55 to 56 mm (2.17 to 2.2 in.)
(A) "CREEP" position
(hands off)
(B) "NEUTRAL" position
(held by hands)
BMAXIMUM SPEED (FORWARD)
Consult your local KUBOTA Dealer for this service.
BMOTION CONTROL LEVER ALIGNMENT
C Check the alignment
Check the gap and space between the levers, at the
maximum forward position.
Recommendation
If positions of the control levers are unequal, an
adjustment is necessary.
To avoid personal injury:
A Park the machine on a firm and level surface.
A Stop the engine, remove the key and apply the
parking brake.
Gap: 0 to 2 mm
(0 to 0.08 in.)
Space:10 to 20 mm
(0.4 to 0.8 in.)
(A) "GAP"
(B) "SPACE"