Cleaning Engine Oil Cooler Fins - Kubota ZG327A-AU Operator's Manual

PERIODIC SERVICE
6. Blow off the debris inside the fan cover as shown in
the figure. Pressure of compressed air must be
under 205 kPa (2.1 kgf/cm
(1) Fan cover
7. Open the oil cooler cover. Remove the debris on
the surface of the dust cover by hand and blow off
small debris with compressed air. Pressure of
compressed air must be under 205 kPa (2.1 kgf/
2
cm , 30 psi).
(1) Dust cover
(2) Oil cooler cover
8. Install the cover with 4 bolts and then the fan cover
with 2 screws.
9. Close the hood.

4. Cleaning engine oil cooler fins

If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
This engine is equipped with an oil cooler. The style of
the oil cooler is mounted on the blower housing.
Pressure of compressed air must be under 205 kPa
2
(2.1 kgf/cm , 30 psi).
WARNING
To avoid serious injury or death:
62
2
, 30 psi).
• Make sure the engine is cool enough to touch
before removing
components.
• Always shield eyes and a face from air deposits
and objects.
1. Stop the engine and apply the parking brake.
2. Remove the cover of the carburetor fuel valve.
(1) Cover
3. Loosen the 2 bolts for the engine oil cooler and
remove the connector.
(1) Oil cooler
(2) Bolt
(3) Connector
EVERY 100 HOURS
shrouds and other
ZG327A-AU