Checking Tire Pressure; Inflation Pressure; Lubricating All Grease Fittings - Kubota ZD1211 Operator's Manual

52 PERIODIC SERVICE
BChecking Tire Pressure
To avoid serious injury or death:
A Do not attempt to mount a tire on a rim. This
must be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Inflation pressure in tires rises quickly when
using compressed air.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Do not use tires larger than specified.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
Tire sizes
15 x 6.5 - 8,
Smooth
Front
semi-pneumatic
Low profile tire
26 x 12.0 - 16,
Rear 4PR Turf
Low profile tire
(1) Ground
Recommended

Inflation Pressure

- - -
83 kPa
(0.84 kgf/cm , 12 psi)
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
BLubricating All Grease Fittings
To avoid serious injury or death:
A Be sure to stop the engine and remove the key
before greasing.
Grease the following location.
(1) Mower universal joint
(1) Spindle shaft
(2) Belt tension pulley
(3) Belt tension pivot
(4) Front anti-scalp roller pivot boss
(5) Front anti-scalp roller