Transceiver Cloning - Yaesu FT-51R Owner's Manual

Transceiver Cloning

You can transfer all data stored in one FT-51R
to another set automatically by a cloning proce-
dure. This requires a user-constructed cable to
connect the jacks on the two transceivers as
EAR
shown below.
I
I
Tip
I
I
I
Construct a clone cable and in-
sert into the EAR jacks as shown.
Turn both units off, then press and hold the
power on again. The display appears as be-
low.
I
I
Tip
I
I
Now insert the clone cable into
of each tranceiver, and press the
destination
the FT-51R.
Top segments move and inner segments rotate, indicating
data transfer from source to destination transceiver.
Next press the
(the display shows
After successful data transfer, the destination
transceiver turns off automatically. If there was a
problem, :;mE
check your cable and then turn both transceivers
off and try again.
Remove the cloning cable. Channel and oper-
ating data for both transceivers are now iden-
tical.
key on
key on the FT-51R
appears on the display, re-
jack
I