Yaesu FT-51R Owner's Manual page 57

Messages subsequently received continu-
overwrite
ously previously full slots on a
first-ou t
order, unless
selected. In this case messages are not stored,
and I
plained later).
To view messages, press
recall message slots using the
tons, then rotate the
message across the lower display. Empty mes-
sage slots are indicated by an asterisk.
To erase all stored messages, turnlihe trans-
ceiver off, then press and hold the
while turning the power on. To erase stored out-
going messages, refer to the box below.
Erasing Outgoing Messages
Stored messages can be individually erased
using the following procedure:
First recall the desired message by holding
for ?h second and using the
the &button
second, then press @to clear the message.
first-in,
Single
message storage is
in the display, (ex-
ID
to scroll the stored
DIAL
button
Hold (OM) again for
Message Storage
After receiving ten incoming messages, any
subsequent messages normally
viously full slots on afirst-in,first-out order. This
is called Continuous message storage.
If you like, you can change to
storing mode, and any additional messages are
but-
not displayed or stored
the display). This protects previous messages
from being inadvertently overwritten:
so that
message storage mode) is displayed.
Use m o r
tinuous or single
Press the
finish.
Received messages are displayed as before,
but only the first ten are displayed and automat-
ically stored for later recall.
overwrite
Single
( I I
then select
(the default continuous
to toggle between con-
message storage.
i
to save the change and
PTT
pre-
message
appears in