Customizing Ringer Settings - Yaesu FT-51R Owner's Manual

Customizing Ringer Settings

The way the transceiver's ringer responds
when a CTCSS Bell, DTMF Paging or DTMF
Message call is received depends on the ringer
configuration you select. Three types of ringer
melodies are available:
Internal Melody (factory-programmed)
User-programmed Melody
Morse Code Annunciator (CW decoder)
The CTCSS Bell
&
be turned off, or else enabled to repeat the se-
lected melody (or Morse announcement) 1 , 3 or
5 times when a call is received.
Note: the Morse annunciator
ing DTMF tones and replays them via the
internal speaker to alert you to incoming
calls and their message.
The DTMF Message ringer can be enabled or
disabled. However, when enabled it only rings
once when using the Morse annunciator. The
User-Melody is stored in DTMF Auto-Dial
Memory 0 (reserved for this purpose), and is
explained in detail later in the chapter (pages 59
The chart shows possible ringer configu-
& 60).
rations.
DTMF Paging Ringer can
decodes incom-
Ringer Repetition Melody
Function (on/off)
CTCSS 0 (off)
Paging (off)
Ringer 1
3
5
Message Off
Ringer On
To confiFure the CTCSS Bell ringer, press
Select
ringer type and
ringer repetition (or off). Use
to toggle function selections.
8
The Message Ringer only uses 5Et
to enable or disable the Morse
Selection
A I (CW Decode)
Decode)
Internal
BELL
for
or