Yaesu FT-51R Owner's Manual page 61

Auto-Dial Memory Playback
You can manually check the contents of
DTMF auto-dial memories while 2 ! S is dis-
played:
Hold (aM) for 1/2
second, then press any num-
bered key (to change the display to auto-dial
memories).
A
Turn the (r)/(r7 keys to select the desired
memory number,
auto-dial
select individual digits and scroll the string
across the display (from right to left). Note
that the serial place of the digit changes ac-
cordingly at the top of the display.
To replay the stored codes in the loudspeaker
and on the display, simply press the num-
bered key corresponding to the DTMF auto-
dial memory number stored.
To play back DTMF auto-dial memories on
the air, first make sure the DTMF memory mode
is activated ("=" is displayed). Then close the
auto-dial memory to transmit. Once the DTMF
sequence has begun, you may release the PTT
(the transmitter stays keyed until the auto-dial
string has been sent).
to
then use the
DIAL
Naming DTMF Auto-Dialer Memories
You may assign a name (up to 8 characters) to
each DTMF auto-dial memory, to be displayed
when the memory is recalled. This can help you
to identify whose numbers you have stored. The
same character set and procedure used for nam-
ing regular memory channels (pages 33-34) is
used for auto-dial memory naming.
Activate the DTMF Auto-Dial mode by press-
(if necessary, to display the
ing
Press and hold (oM) for 1/2-second (until the
second beep sounds). Then press the num-
bered key corresponding to the desired DTMF
memory to be named.