Yaesu FT-51R Owner's Manual page 49

After pressing (OM)+-=
setting you can press (OM> to toggle DTMF
squelch paging capability on and off. When on,
that is, when the decoder
is enabled to receive pag-
ing calls with this Code
Memory, a small underbar
appears
beneath the Code
Memory digit.
Only enable the underbar for those Code
Memories you wish to monitor, it should not
appear for others. As mentioned before, this dis-
tinction does not apply to Code Squelch (non-
paging) operation the underbar has no effect.
-
Note that the underbar is displayed perma-
nently on Code Memory
own ID (that you will always want to receive
when paging is activated). Also, the underbar
never appears on Code Memory
reserved for the display of incoming codes.
Once you have stored your own ID Code in
Code Memory you can activate the paging or
code squelch functions from the normal fre-
quency display by pressing
earlier in the CTCSS Bell procedure, repeatedly
pressing this key cycles through DTMF paging
to activate Code
Code Memory enabled
for
Paging
since this is your
since this is
CODE C
As mentioned
displayed), trigger paging
(PAGE
squelch CTCSS Bell paging
(CODE),
paging (none of these symbols).
DTMF Code Squelch Operation
As described earlier, with DTMF code
squelch activated (CODEdisplayed), your
squelch will not open until you receive the
proper 3-digit DTMF code according to the se-
lected code memory. Likewise, each time you
press the the same 3-digit code is automat-
PTT,
ically sent to open the other station's DTMF
coded squelch.
Using Paging
DTMF
Any DTMF-equipped station can call you by
sending your 3-digit code, followed by their 3-
digit ID Code. When a valid paging tone se-
quence is received, several things happen:
The ringer sounds (unless you disabled it, as
described on page 56).
The PAGEicon blinks, and the LCD and key-
pad illuminate (if so enabled).
The code of the calling station and any follow-
ing messages (covered later) scroll across
across the lower display. The code of the pag-
ing station in now stored in code memory
code
and no
.