Yaesu FT-51R Owner's Manual page 60

DTMF Auto-dial Memories
Ten memories, numbered 0
tone sequences of up to 15 digits each. These can
be used for remote DTMF control sequences or
telephone numbers for auto-patching systems.
Memories 0 & 9 are reserved for a special pur-
pose, and are covered later.
A special mode must be activated to use the
DTMF auto-dial memory features, o : E d is tog-
gled on and off by pressing
icon is displayed at the far right when this mode
is active.
To store a DTMF Auto-Dial Memory:
Press (OM>+&,
pears in the right side of the display.
Press and hold (OM> for %second (until the
second beep sounds), then within 5 seconds,
numbered key
press
Auto-Dial memory number you want to store.
Press and hold (OM> again for %-second (
begins to blink), then key in the numbers of
the DTMF sequence you wish to store. As you
do so, the blinking serial digits place at the left
side of the display increments automatically
as the entered digits are displayed at bottom.
-
9, store DTMF
The
ap-
corresponding to the
I I
Selected DTMF Autodial Serial digit's place (1-15)
of last-entered digit.
I
DTMF Autodial Digit String displayed hire
(up to 8 digits of the string can be viewed at
Entering Auto-Dialer digits (example)
Note: when entering new DTMF codes, the two-
place serial digit number shows
be stored
indicated by the blinking
-
If you make a mistake, press
and re-enter your digits. To erase an existing
Auto-dial memory, enter the Auto-dial program
mode must be blinking), and press
If storing fewer than 15 digits, press
finish (if you store the full 15 digits, entry
terminates automatically after the last digit).
Press or to select another DTMF mem-
ory to store, if desired, and repeat the last two
steps, or press (CALL) again to exit and return to the
frequency display.
one
time)
the next digit to
.
BAND OFFr4
to backstep
(BAND)
to